The production of stamping parts belongs to the material forming technology, which is a new metal cold deformation processing method that has appeared in recent years. It is one of the main methods of metal plastic processing. In the production of stamping parts, people use the power of traditional or special stamping equipment to stamp, use pressure to deform the material, and then use the metal plate in the mold to deform the part with a certain size.
In the production of stamping parts, attention should be paid to the use of engineering equipment such as presses or molds under normal conditions of use. This effectively prevents the strip from being transported along the correct location or gap pre-booked by us. We, ah, make sure all parts are tight. In the production of stamping parts, do not change the installation position of the stamping die. Once they change, they will scratch or crush the surface of the workpiece. In this way, the quality of the workpiece is greatly affected.
Another point is that when preparing raw materials, you must abide by the technical specifications, pay attention to the accurate measurement of raw material particle size, and strictly carry out raw material inspection and card inspection. At the same time, in the production of stamping parts, it is necessary to carefully and regularly check the abrasive tools and some punching machines to prevent the wear of the working parts and guide parts caused by long-term operation. Strictly abide by all relevant precautions during the production of stamping parts to avoid unnecessary losses.
