Stamping parts processing plants process all kinds of stamping parts products, including round stamping parts, so what are the steps and features when producing round stamping parts?
1. Need to form round stamping parts;
2. Put the formed round stamping strip material body into a two-cavity blanking die for stamping processing. During the stamping process, the first positioning of the strip body is positioned by two inclined edges in the parallelogram length direction, and then the positioning of the strip body is positioned by the hole edge of the round stamping part after blanking;
3. If in order to improve the processing efficiency, two rows of circular stamping parts can be set in the material strip, and the two rows of circular stamping parts are staggered; when stamping parts are processed, the positioning of the material strip depends on the four sides of the rectangular material strip Although this method improves the processing efficiency, the utilization rate of the stamping material is not high, which relatively increases the processing cost;
4. The horizontal cross-section of the formed round stamping parts is parallelogram, and the two sides of the parallelogram are inclined in the longitudinal direction. The round stamping parts made with this strip can improve the material utilization rate and reduce the processing cost; at the same time, stamping During processing, each time the stamping is performed, the material strip must be positioned once, and the quality of the round stamping parts produced will be better
