Before producing stamping parts, stamping parts processing plants must first design stamping dies. Good stamping dies are important equipment for making metal stamping parts. What are the steps in the design of stamping dies?
1. The first is to search for the original materials of mold design, which is an indispensable technical preparation before mold design;
2. Review the stamping product drawing and process card, review the product drawing and process on the basis of the original data, analyze the stamping processability of the product parts, and see if the process is formulated and whether each process sketch is reasonable. If it is found that the stamping process is poor or the process plan formulated is unreasonable, you should submit a modification opinion to the product design and process design department, and modify it after approval. Only in this way can product design, process preparation and mold design, mold manufacturing The combination of direct replacement achieves better results;
3. Perform relevant process calculations, and perform relevant process calculations for each process according to the content of the process specified in the stamping process card;
4. Draw the assembly drawing of the mold and other parts;
5. Check the mold drawing. After the mold drawing design is completed, it must be checked. This is an indispensable step in the design of stamping parts;
6. Compile the stamping design calculation specification. The design calculation description is an important technical document, especially for the process formulation and mold design of some important employees; at the end of the design work, the design calculation specification should also be written.
